Tuesday 16 June 2015

Wooden Swing Seat with Support Frame

Wooden Swing Seat with Support Frame


Introduction


The footprint (ground area) of this swing seat support frame is 2700mm (9ft) x 2100mm (7ft).
The overall height is 2025mm (81").


Although this support frame is purposeful for a selected swing seat, it may also be accustomed support varied alternative utilities like swings or even a glide-ride, and is even capable of accommodating sure kinds of athletic facility instrumentality.
It is a awfully solid frame and essentially consists of 2 finish A-frames designed to attenuate front and back movement, a beam that sits on prime and 2 braces designed to attenuate sideways movement.

The lumber utilized in this project is one hundred by one hundred (4x4) stock, which implies that the lumber is one hundred millimeters (4") wide by one hundred millimeters (4") thick. this can be a awfully ordinary shares size and may be promptly getable from most lumber or building offer yards. If you favor to use swish lumber as critical rough, that typically means the wood has been planed or dressed and so the scale of the lumber are going to be slightly smaller, however that doesn't matter. most vital is that the lumber is appropriate for out of doors use and powerful enough for the duty, that essentially suggests that the stock ought to be fairly straight-grained and contain only a few knots - positively no huge knots. Your native lumber provider are going to be able to advise you on the foremost appropriate kinds of lumber on the market and additionally what safety precautions would possibly got to be taken whereas operating with any explicit form of lumber. for instance, once operating with treated lumber you may got to wear acceptable consumer goods, gloves and mask whereas cutting or shaving and sure waste disposal and shut down rules should be adhered to.

Individual Items

1) A frame leg 100x100 (4x4) stock appropriate for exterior use. Cut four items to length as shown higher than. Angle cut every finish twenty six.6 degrees off sq.. there's additional info on the way to mark and cut the angles within the instruction page.

2) Horizontal brace 100x100 (4x4) stock appropriate for exterior use. Cut 2 items to length as shown higher than. Angle cut every finish twenty six.6 degrees off sq..

3) Diagonal brace 100x100 (4x4) stock appropriate for exterior use. Cut 2 items to length as shown higher than. Angle cut every finish forty five degrees off sq..

4) Beam 100x100 (4x4) stock appropriate for exterior use. Cut one piece to length as shown higher.

Do you have a Wooden Swing at Home?